CorStop Tape in three sizes, 25mm, 50mm & 100mm
(Zinc Tape; The Ultimate assistant to protect against unwanted corrosion.)
CORSTOP Tape is developed to cover the surface of several metals in order to protect them against corrosion. This is achieved by applying CORSTOP Tape to the surface that needs to be protected. This method is commonly known as “Coating with a Zinc layer”. The adhesive layer, which is applied only on one side of the CORSTOP Tape, consists of a mixture of adhesive and a percentage of Zinc powder.
CORSTOP Tape is used for:
- Protection against any direct corrosion
- Active anticorrosive protection thanks to the electrical contact between the surface to be
protected and the Zinc layer which, in the presence of an electrolyte, reacts as a scarifying anode.
- Additional defence against corrosion, due to the presence of an adhesive layer anchored on the surface to be protected.
Active anticorrosive protection thanks to the electrical contact between the surface to be protected and the zinc layer, which in the presence of an electrolyte, reacts as a scarifying anode Presence of an adhesive layer, anchored on the surface to be protected, which is an additional defense against corrosion. The coating with our zinc layer assures a cathodic protection of metallicsurfaces for a time, that, in most cases, is equal or longer than the lifetime of the structure to be protected.
Special developed noncorrosive pure (>99,9%) zinc Layer. CORSTOP Zinc Layer is UV resistant and will not be affected by water, gas etc. Corrosion will not happen from the inside. CORSTOP is temperature resistant till 80°C, the silicon backliner gives ultimate protection against pollution.
Our “CORSTOP Tape”, is available in rolls in below mentioned sizes:
|67 35 21||25 mm||20 mtr||0,1 mm|
|67 35 22||50 mm||20 mtr||0,1 mm|
|67 35 23||100 mm||20 mtr||0,1 mm|